Contact us at lnz@larsonjuhl.com or Phone Toll Free 09 256 0020
Customer service Login


Select Below to View Cassese & Fletcher Technical Support Videos

 


  • Cassese CS88/89 Underpinners


How to replace the Hammer on a Cassese CS88 - CS89 Underpinner
How to replace the wedge pusher spring in a CS88-89 Underpinner
How to remove & Clean the Distributor Block on a Cassese Underpinner
Checking & Replacing the End-of-Travel Switch on a Cassese Underpinner

  • Cassese CS199/CS299 Underpinners


How to replace the Hammer on a Cassese Pneumatic Underpinner
How to remove & Clean the Distributor Block on a Cassese Underpinner? ???
How to replace a hammer retaining screw on a Cassese Underpinner
Checking & Replacing the End-of-Travel Switch on a Cassese Underpinner

  • Cassese CS2-CS20 Underpinners


Opening the Front Panel of a Cassese CS20 & CS2 Underpinner
Opening the Rear Panel of a Cassese CS20 & CS2 Underpinner? ???
Opening the Side Access Panel on a CS1-2-20 Underpinner
Stacking Wedges with a Cassese CS20 Underpinner? ???
Adjusting the Clamp Strength on a Cassese CS20 Underpinner
Installing an Extension Table on a Cassese CS1-CS2-CS20 Underpinner
How to replace the wedge wire strainer cable on a Cassese CS20 Underpinner
How to replace an elastic wedge pusher spring cord on a CS1-2-20 Underpinner? ???
How to check and/or replace the pneumatic end-of-travel switch on a CS20 Underpinner

  • Cassese CS200 Underpinners


How to open the side panels for the CS200 Mach 1-4? ??
How to remove the top working table for the CS200 Mach 1-4

  • Cassese Mach1 / Mach 4 Underpinners


How to access the electronics drawer for the MACH 1-4? ???
How to open the side panels for the CS200 Mach 1-4? ??
How to remove the top working table for the CS200 Mach 1-4
How to replace the stepper motor and power drive for the Mach 1-4

  • Cassese Cutters & Saws


How to change the blades of your Guillotine
How to adjust the underknives of your Guillotine
How to adjust the blade clearance of your rebate supports for your Guillotine.???
Basic Overview of Cassese Smartstop User Interface

  • Fletcher Terry


How to set-up and use the Fletcher 2200 Matcutter
How to set-up the Fletcher 3100 Glass & Board Cutter



Loading
Loading